Zanussi Repair Service

What does Zanussi dishwasher error code i60 mean?

Error code i60 on a Zanussi dishwasher indicates a heating problem. The water temperature inside the appliance is too high or the temperature sensor has malfunctioned. Switch off and unplug the dishwasher. Ensure the incoming water temperature does not exceed 60°C. Clean the filter and sump, then reconnect and run a test cycle. If the error persists, contact a qualified technician.

What does Zanussi washing machine error code E30 mean?

Error code E30 on a Zanussi washing machine indicates a water leak or pressure sensor problem. Water has been detected at the bottom of the machine. Close the water supply immediately. Do not step on water that may be in contact with the appliance while plugged in. Unplug only if you can do so safely without contact with water. Check the door seal for damage and the water supply hose connections for leaks. Do not use the machine until it has been inspected by a qualified technician.

What does Zanussi dishwasher error code i30 mean?

Error code i30 on a Zanussi dishwasher indicates a water leak. The anti-flood protection has been activated. Close the water supply immediately. Do not step on water that may be in contact with the appliance while plugged in. Unplug only if you can do so safely without contact with water. Leave overnight to allow foam to disperse, and check for leaks around the door seal and hose connections.

What does Zanussi dishwasher error code i20 mean?

Error code i20 on a Zanussi dishwasher indicates a drainage problem. Switch off and unplug the dishwasher before any inspection. Check the drain filter and sump are clean, the drain hose is correctly installed, and the sink drain is not blocked.

What does Zanussi oven error code F1 mean?

Error code F1 on a Zanussi oven indicates a door closure problem or electronic fault. For ovens with pyrolytic cleaning, the door may not be closing correctly because the pyrolytic function is active. Switch off and unplug the oven. Allow it to cool completely (at least 60 minutes) before any inspection. Check that the door is intact and properly secured. If the error persists, contact a qualified technician.

What does the E20 error code mean on my Zanussi washing machine?

The E20 error code indicates a drainage problem. The drain filter may be blocked or the drain hose may be kinked or incorrectly positioned. Clean the drain filter and check that the drain hose is not obstructed. If the pump has overheated, switch off the machine for 1 to 2 hours to allow the safety thermostat to reset, then try again.

Why does my Zanussi hob display P?

The P message indicates that the Power Boost function is activated. This allows maximum heat setting for 10 minutes, after which the temperature returns to the previously set value.

How often should I clean my Zanussi tumble dryer filter?

Clean the fluff filter after every drying cycle. The filter collects lint during drying, and a clogged filter leads to longer cycle times, unsatisfactory drying results, and increased energy consumption.

How do I clean my Zanussi tumble dryer filter?

Pull out the fluff filter from the bottom of the door opening - it opens like a book. Empty the lint into the bin and if needed, clean the filter with a vacuum cleaner or wet cloth.

Why won't my Zanussi washing machine start?

Check that the door is completely closed - you should hear an audible click. If the washing machine is overloaded or excess laundry is blocking the door, the programme will not start. Remove some laundry and try running the programme again. Also check if the delay start function is active.