Faber Repair Service

Why does my Faber cooker hood run at high speed for only 6 minutes?

When your Faber cooker hood runs at maximum speed and automatically reduces after 6 minutes, this indicates the intensive speed mode is functioning correctly. This timed feature provides maximum extraction power for heavy cooking tasks such as frying or grilling, then automatically returns to a lower speed to conserve energy. This is normal operation, not a fault.

Why does my Faber cooker hood turn on briefly every hour?

If your Faber cooker hood activates for approximately 10 minutes every hour, the 24-hour air circulation mode is enabled. This eco-friendly feature maintains fresh air in your kitchen by periodically ventilating at low speed throughout the day. To deactivate this mode, press and hold the designated button for approximately 2 seconds with the motor and lights off. Consult your instruction manual for model-specific controls.

What does it mean when the LED flashes twice on a Faber cooker hood?

Two LED flashes on a Faber cooker hood can indicate either that the remote control receiver has been activated, or that the activated charcoal filter alarm has been enabled. This is a confirmation signal showing the hood has registered your command.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

How often should I clean the metal grease filters on my Faber cooker hood?

Metal grease filters should be washed every 2 months under normal cooking conditions (up to 3 hours of use per day). This equates to approximately every 100 hours of hood operation.

What are the benefits of LED lighting in Faber cooker hoods?

LED lighting in Faber cooker hoods provides bright, even illumination across the entire cooking area while using significantly less energy than traditional halogen bulbs. LEDs also have a much longer lifespan and produce less heat, contributing to the overall energy efficiency of the hood.

What is the minimum installation height for a Faber cooker hood above a gas hob?

The minimum distance between the cooker hood and a gas hob must be at least 75cm. This increased distance is required due to the open flames and heat production from gas burners.

What is the difference between ducted and recirculating Faber cooker hoods?

Ducted hoods expel cooking fumes directly outside through external venting, offering superior odour removal and quieter operation. Recirculating hoods filter the air through charcoal filters and return it to the kitchen, offering flexibility as they can be installed anywhere without external ducting.

How often should I deep clean the inside of my Faber cooker hood?

Deep clean the interior of your cooker hood and the duct inside the hood once a year. This includes cleaning all accessible internal surfaces where grease may have accumulated beyond the filters.